Skip to main content

Correction to: Use of a life-size three-dimensional-printed spine model for pedicle screw instrumentation training

The Original Article was published on 16 April 2018

Correction to: J Orthop Surg Res 13, 86 (2018)

https://doi.org/10.1186/s13018-018-0788-z

Following the publication of the original article [1], the authors found out mistake on the authorgroup section. Jung Hoon Shin who is not listed in the authors' list carried out the study but passed away before the submission of the study. The authors want to thank him for his contribution to the study. Kook Jin Chung who is not listed in the authors' list contributed to the conception of the study and carried out the study and should be the corresponding author. Hyun Jin Park, Chunyu Wang, and Kyung Ho Choi did not contribute to the study. The corrected author group is shown above.

Reference

  1. Park HJ, Wang C, Choi KH, et al. Use of a life-size three-dimensional-printed spine model for pedicle screw instrumentation training. J Orthop Surg Res. 2018;13:86. https://doi.org/10.1186/s13018-018-0788-z.

    Article  PubMed  PubMed Central  Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Kook Jin Chung.

Rights and permissions

Open Access This article is licensed under a Creative Commons Attribution 4.0 International License, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons licence, and indicate if changes were made. The images or other third party material in this article are included in the article's Creative Commons licence, unless indicated otherwise in a credit line to the material. If material is not included in the article's Creative Commons licence and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder. To view a copy of this licence, visit http://creativecommons.org/licenses/by/4.0/. The Creative Commons Public Domain Dedication waiver (http://creativecommons.org/publicdomain/zero/1.0/) applies to the data made available in this article, unless otherwise stated in a credit line to the data.

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Chung, K.J., Kim, H.N. Correction to: Use of a life-size three-dimensional-printed spine model for pedicle screw instrumentation training. J Orthop Surg Res 16, 303 (2021). https://doi.org/10.1186/s13018-021-02429-y

Download citation

  • Published:

  • DOI: https://doi.org/10.1186/s13018-021-02429-y